polyline2d


Creates a polyline from a list of x, y coordinates. When the end points are CAP_ROUND, you can use $fa, $fs or $fn to controll the circle module used internally. It depends on the line2d module so you have to include line2d.scad.

Parameters

  • points : The list of [x, y] points of the polyline. The points are indexed from 0 to n-1.
  • width : The line width.
  • startingStyle : The end-cap style of the starting point. The value must be "CAP_BUTT", "CAP_SQUARE" or "CAP_ROUND". The default value is "CAP_SQUARE".
  • endingStyle : The end-cap style of the ending point. The value must be "CAP_BUTT", "CAP_SQUARE" or "CAP_ROUND". The default value is "CAP_SQUARE".
  • $fa, $fs, $fn : Check the circle module for more details. The final fragments of a circle will be a multiple of 4 to fit edges if possible.

Examples

include <line2d.scad>;
include <polyline2d.scad>;

$fn = 24;
polyline2d(points = [[1, 2], [-5, -4], [-5, 3], [5, 5]], width = 1);

polyline2d

include <line2d.scad>;
include <polyline2d.scad>;

$fn = 24;
polyline2d(points = [[1, 2], [-5, -4], [-5, 3], [5, 5]], width = 1,
           endingStyle = "CAP_ROUND");

polyline2d

include <line2d.scad>;
include <polyline2d.scad>;

$fn = 24;
polyline2d(points = [[1, 2], [-5, -4], [-5, 3], [5, 5]], width = 1,
           startingStyle = "CAP_ROUND", endingStyle = "CAP_ROUND");

polyline2d